BARCO F50 DLP projector with High Frame Rate

Barco comes a new professional projector, the F50, addressed to the market Training and Simulation. The technology used is a single DLP chip, with a WQXGA resolution, 2560 x 1600 pixels. Brightness is between 1800 and 5000 lumens (depending on the mode of use), with a contrast ratio of 1800:1 to . The luminous flux is provided by a 350W UHP lamp, guaranteed for a period of 3000 hours in Eco mode or 2500 hours at full power. The shooting and the lens shift depend optics choice (provided there are 6).

To make this interesting product features are: F50 is primarily compatible with the signals High Frame Rate, which is the same format used by HFR Peter Jackson for The Hobbit. You can then view the input sources to 120Hz. Another very significant, especially for the field of use, support for the standard HDBaseT, which allows you to send an audio signal-uncompressed video up to 100 meters, using a single CAT5e or CAT6 cable. There are also compatibility with 3D sources (via active glasses), a technology designed specifically for the reduction of motion blur and specific software tools for SimCAD.

The connections available include 2 DisplayPort 1.2, 1 DVI-D Dual Link, 1 HDMI 1.4a, 1 VGA, 2 3G-SDI, 1 10/100/1000 port for HDBaseT, 1 RJ45, 1 RS-232 port and a USB type A. F50 will be available for inspection at the Barco booth at I / ITSEC conference, to be held December 2 to 5 in Orlando, Florida.

Read another very interesting article about alternative energy of the Sun, water and air.

Look a video from russian roads:

Leave a Reply

Your email address will not be published.